A wildfire in the Willard hills of North Ogden has prompted evacuations as it threatens nearby homes. The Willard Peak Fire began on Wednesday afternoon, August 13, from a vehicle fire that spread uphill, as per FOX13. Utah Fire Info (UFI) estimated the fire to be 50 to 75 acres and uncontained.
In an X post, it wrote, “#WillardPeakFire (formerly #NorthOgdenFire) is 50–75 acres in flashy fine fuels & gamble oak. Ground crews & aircraft engaged. Evacuations ordered E of 1050 E & N of 3300 N by North Ogden PD. If told to evacuate—leave. Avoid the area. Human-caused. #ffslkmg”
As per the KSLTV, North Ogden police ordered evacuations for residents east of 1050 East and north of 3300 North. Officials urged people to follow evacuation orders and avoid the area.
The American Red Cross Northern Utah Chapter has opened a 626 E. 2600 North shelter for evacuees.
In an earlier post, UFI announced the name change of the #NorthOgdenFire to the #WillardPeakFire.
As per FOX13, Multiple fire crews are on the scene, with helicopters and air tankers dropping water and fire retardant.
The poweroutage.us map shows that as of 6.39 p.m. MT, over 30,000 residents were without power after Rocky Mountain Power de-energized lines for safety. Crews are working to restore electricity as soon as possible.
FAQs
What is the current status of the Willard Peak Fire in North Ogden?
The Willard Peak Fire, sparked by a vehicle fire, is currently 50 to 75 acres and remains uncontained as of Wednesday evening, August 13, 2025.
Which areas in North Ogden are under evacuation orders due to the fire?
Evacuations have been ordered for residents east of 1050 East and north of 3300 North. Officials advise everyone to follow instructions and avoid the affected area.
Where can evacuees from the North Ogden wildfire go for shelter?
The American Red Cross Northern Utah Chapter has opened an evacuation shelter at 626 E. 2600 North, Ogden, for residents displaced by the Willard Peak Fire.
Why is the North Ogden fire now called the Willard Peak fire?
The Incident Commander typically names wildfires after a nearby geographical feature or the area closest to where the fire started. Names may also change if there was a recent incident with the same name in the fire dispatch system.